Page 22 - CC2018_WD_Look_Inside

4. Repeat Step 3 with the bottom-center handle until feedback shows the area of
H: 11.250 in.
Note:

You can press the Escape
key to cancel the crop
marquee and return to
the uncropped image.

Note:
You can rotate a crop
marquee by placing the
Remember, the defined trim size for this ad is 8.53 1 113. Anything that runs to the cursor slightly away from
page edge has to incorporate a 0.1253 bleed allowance, so the actual canvas size must be a corner handle.
large enough to accommodate the bleed allowance on all edges:

[Width] 8.53 + 0.1253 + 0.1253 = 8.75
[Height] 113 + 0.1253 + 0.1253 = 11.25

5. Zoom out until you can see the entire canvas in the document window.

6. Click inside the crop area and drag to reposition the image so that it is
approximately centered in the crop area.
When you change the size of the marquee, the area outside the marquee is “shielded” by
a darkened overlay so you can get an idea of what will remain after you finalize the crop.

You can drag the image inside the crop area to change the portion that will remain in
the cropped image. By default, the crop area remains centered in the document window;
instead, the image moves behind the crop area.
Note:
You can also use the
Arrow keys on your
keyboard to “nudge”
the image in a specific
Click and drag inside direction.
the crop area to change
the portion of the
image inside the crop. Note:
It might be helpful
to toggle off the Snap
feature (View>Snap),
Areas outside the which causes certain
crop marquee are file elements to act as
partially obscured.
magnets when you move
a marquee or drag a
selection.
7. Press Return/Enter to finalize the crop.

32 Project 1: Composite Movie Ad